Table of Contents
Advertisement
3.
Install the boot device carriers:
a. If closed, pivot the carrier latch to open.
b. Slide the carrier into the boot device cage (callout 1).
c. Pivot the latch to close (callout 2).
Make sure that the carrier latch is locked on the boot device cage.
Installing the boot device
4.
Power down the server.
5.
If installed, open the cable management arm.
6.
Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
7.
Disconnect all peripheral cables from the server.
8.
Remove the server from the rack.
9.
Remove the access panel.
10. Do one of the following:
Remove the air baffle.
•
Remove the midplane drive cage.
•
11. Connect the signal and power cables to the boot device.
Hardware options installation
184
Advertisement
Table of Contents
