Table of Contents
Advertisement
Procedure
1.
Power down the server.
2.
If installed, open the cable management arm.
3.
Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4.
Disconnect all peripheral cables from the server.
5.
Remove the server from the rack.
6.
Remove the access panel.
7.
Install the chassis intrusion detection switch:
a. Insert the switch tab into the chassis slot until the switch clicks into place (callout 1).
b. Connect the switch cable and secure it in the cable clamp (callout 2).
8.
Install the access panel.
9.
Install the server into the rack.
10. Connect all peripheral cables to the server.
11. Connect the power cords:
a. Connect each power cord to the server.
b. Connect each power cord to the power source.
Hardware options installation
201
Advertisement
Table of Contents
