Initiating Firmware Upgrade Mode From The Terminal Program - evertz HD9626DSK Instruction Manual

HD9626DSK Instruction Manual
6. You can invoke the Firmware upgrade mode using the front panel Setup Menu. (See section 3 for
information on how to operate the front panel menus.) Press the SETUP button to enter the top
level of the Setup menu. Use the
press the SELECT button. Use the
then press the SELECT button. Use the
item and then press the SELECT button.
Once the SELECT button is pressed the keyer unit will be placed in programming mode and its
serial port is opened to communicate with the terminal software program. The following message
will appear on the terminal screen
Proceed to section 5.2.5 for instructions on uploading the firmware using the terminal program.

5.2.4. Initiating Firmware Upgrade Mode from the Terminal Program

7. Power up the unit. After the unit powers up, a banner with the boot code version information should
appear in the terminal window. A series of characters are slowly displayed after the upload main
program line. (The symbol displayed may vary from that shown in the figure). The symbol used
depends on the font selected for use with HyperTerminal.
Page 5-4
or pushbuttons to find the GENERAL menu item and then
or pushbuttons to find the Update Code menu item and
or pushbuttons to find the yes-upgrade now menu
Revision 1.4
TECHNICAL DESCRIPTION