Table 2-1: Upgrade Rs232 Port A Pin Definitions; Table 2-2: Remote Panel Port Pin Definitions - evertz HD9626DSK Instruction Manual

High definition downstream keyer series

Hide thumbs Also See for HD9626DSK:

Instruction manual (38 pages)

Table Of Contents

Table of Contents

HD9626DSK Instruction Manual

REMOTE PANEL (B): This 9 pin female D connector provides an RS-422 serial interface for

connection to the optional Rack Mount Remote Control Panel (RCP) or Desktop

Remote Control Panel (DCP) supplied with the keyer package. This port is wired as

a SMPTE 207M Tributary as shown in Table 2-2. See section 2.4 for information on

connecting the Evertz remote control panel. This DB9 connector will only be installed

if you purchased either of these

SERIAL CONTROL C: This 9 pin female D connector provides an RS-422 or RS-232 serial interface

used for controlling the unit through automation. Operational mode (422 or 232) can

be set from the front panel. Default mode from the factory is RS-422.

COM D:

This 9 pin female D connector provides a serial interface designed for connection to

Automation Systems including the Evertz MetaCast 2 software.

jumper J20 on the 7700FC card can change this port to run in either RS422 or

RS232 mode, which is inside the unit. When it is set for the RS-232 mode of

operation the port has the same pinout as Port A (shown in Table 2-1). When it is set

for the RS-422 mode of operation the port has the pinout shown in Table 2-3.

The RS-422 pinout for the COM D port is not a standard SMPTE RS422 pinout.

You will have to make a custom cable in order to use this port in the RS422

configuration.

Page 2-2

Pin #

Sig Gnd