Setting The Transition Swap Mode; Pausing A Transition; Preset Configuration Items - evertz HD9626DSK Instruction Manual

3.8.3. Setting the Transition Swap Mode

TRANSITION
Transition Swap
Swap: Swap
Swap: No Swap

3.8.4. Pausing a Transition

TRANSITION
Transition Pause
Pause: Off
Pause: On
3.9.

PRESET CONFIGURATION ITEMS

The HD9626DSK keyer has 10 user presets that can store pre-defined configurations for such things
as Matte settings, Transition settings and DSK settings. Therefore if you would like to store a preset
that has a 2.35 matte applied, you must first configure the Matte Aspect and Matte Enable menu items,
then store the preset at one of the user preset addresses. When presets are recalled, the settings are
recalled to the preview bus and will not show on the program bus until the TRANSITION button is
pressed, or a GPI trigger invokes the transition.
The PRESET Setup menu is used to store and recall user presets as well as configure the GPI and
GPO functions. Table 3-5 shows the items available in the PRESET Setup menu. Sections 3.9.1 to
3.9.6 provide detailed information about each of the sub-menus.
After upgrading the HD9626DSK with new firmware, all presets should be recalled
using the Recall Preset menu item, the values for new features must be set, and the
preset must be saved again using the Store Preset menu item.
IF THIS IS NOT DONE, OLD PRESETS COULD BE RECALLED WITH UNDESIRABLE
SETTINGS.
OPERATION
This menu item is used to set the time for the transition to complete. The
duration is measured in frames.
When set to Swap the input video and audio of the preview bus and the
program bus will be swapped at the end of the transition. Logos and other
media being keyed on the respective buses will also be swapped with the
inputs.
When set to No Swap the input video and audio of the preview bus will be
transferred to the program bus transition. Logos and other media being
keyed on the preview bus will also be transferred to the program bus. The
preview bus will remain unchanged.
This menu item is used to set whether the Transition can be paused.
When set to On, the transition may be paused by pressing the
TRANSITION button while the transition is being performed. To continue
the transition, press the TRANSITION button again.
When set to Off, the transition cannot be paused.
Revision 1.4
HD9626DSK Instruction Manual
Page 3-15