Table of Contents
Advertisement
GENERAL
Reference Timing
V: 0 to max lines
3.5.3. Viewing and Updating the Firmware Version
GENERAL
Update Code
1.0 build 100
boot 1.01
Upgrade firmware
3.5.4. Configuring the Output Mode for the Keyer
GENERAL
Output Mode
A/B Mix
Fill/B
3.5.5. Setting Up the Units Network Addresses
The Network Info sub-menu of the General Setup menu is used to configure the unit for FTP uploads
of firmware. In most cases you will only have to plug in your Ethernet cable and configure the network
IP address (A) to contain an unused IP address in the valid range. Entries are made in standard IP
address format. Please consult your Network administrator for IP address allocations, netmask and
gateway requirements.
OPERATION
This menu item allows you to set the vertical timing of the output video with
respect to the genlock reference input. Setting this control to 0 keeps the
output video in time with the genlock reference.
Increasing the value will delay the output video in one-line increments. In
order to advance the vertical timing of the output video with respect to the
genlock video, set the control to the maximum number of samples per line
for the output video standard minus the number of samples that you wish to
advance the output video.
number of samples per line is 2200, so to advance the output video 5
samples set the value to 2195.)
The Update Code menu item allows the user to view the firmware version
that is installed in the HD9626DSK and to update the firmware.
When you press the SELECT pushbutton, the display shows the software
version which will look similar to the following:
1.0 build 100
Use the
or
pushbuttons to display the boot code version which will look
similar to the following:
Boot 1.01
Select Upgrade firmware to upgrade the firmware in the HD9626DSK. For
information on completing the firmware upgrade see the Firmware Upgrade
section 5.2 of this manual.
The user can configure the downstream keyer to behave in two different
modes.
A/B Mix: 2x1 downstream keyer with a DSK Program A and B
Fill/B: DSK mode (Fill is used, B is not used at all)
Revision 1.4
HD9626DSK Instruction Manual
(E.g. for 1080i/59.94 output video the total
Page 3-7
Advertisement
Table of Contents
