Setting Up The Ip Address; Setting Up The Sub Net Mask; Setting Up The Gateway; Displaying The Ethernet Hardware Address - evertz HD9626DSK Instruction Manual

HD9626DSK Instruction Manual
To set the various Network Info parameters, press the SELECT button when the desired parameter is
shown on the front panel display (indicated by the letter on the left side of the display). The left group
of digits will be flashing to indicate that they are in entry mode. Use the
this group to the desired value. Then press the SELECT button and the next group of digits will be
flashing to indicate that they are in entry mode. Set the remaining groups of digits in the same way.
When you have entered the correct value for the right group of digits, press the SELECT button to set
the parameter. The display will stop flashing to indicate that the parameter value has been set. The
settings become active immediately after you exit the Network Info menu level. A reboot is not
required.
3.5.5.1.

Setting Up the IP Address

GENERAL
Network Info
A 196.168.1.1
3.5.5.2.

Setting Up the Sub Net Mask

GENERAL
Network Info
M 255.255.255.0
3.5.5.3.

Setting Up the Gateway

GENERAL
Network Info
G 192.168.1.1
3.5.5.4.

Displaying the Ethernet Hardware Address

GENERAL
Network Info
0:2:C5:01:03:E2

3.5.6. Setting the Serial Protocol for the Serial Ports

The serial ports on the HD9626DSK are used for various functions. The UPGRADE RS-232 (A) port is
used for upgrading firmware and other utility functions. The REMOTE PANEL (B) port is used to
connect the rack mount remote control panel. The SERIAL CONTROL (C) and the COM D port is
programmable and can be used for a variety of functions.
Page 3-8
This menu item sets the unique IP address of the HD9626DSK within the
network. 192.168.1.XXX is an example of an IP address in a private
(internal) network. If connecting multiple downstream keyers, take care not
to use the same IP address for each.
This menu item sets the "subnet mask" of the network. Specifically, this
parameter outlines all the IP addresses that can communicate with the
HD9626DSK. This parameter is usually set to 255.255.255.0 for a private
network. Normally you will not have to adjust this parameter from its default
value.
This menu item identifies the IP address of the "gateway" (commonly
referred to as the "firewall"). In its simplest sense the gateway could be the
PC directly connected to the HD9626DSK and running the network
application software (i.e. InstaLogo or Nomad). In a private network, this
gateway could be identified as 192.168.1.YYY. Normally you will not have
to adjust this parameter from its default value.
This menu item displays the Ethernet hardware address of the unit (which
cannot be changed).
Revision 1.4
or pushbuttons to change
OPERATION