Table of Contents
Advertisement
HD9626DSK Instruction Manual
4.1.4. Control Panel Status Indicators
BYPASS:
Pressing the BYPASS button will force the relay on the input of the I/O module to
disengage. This will route the incoming video directly out through the relay bypass
output connector. The LED inside the BYPASS button illuminates to indicate that the
unit is in manual Bypass. Pressing the button once again energizes the relay allowing
the input video to pass through the unit. The BYPASS relay will disengage if the frame
loses power preserving the video output stream.
connector is bypass relay protected, all other outputs will not function on a power loss.
The bypass option must be purchased for HD units and may not be installed in your unit.
SD units have a bypass as a standard feature.
THRESHOLD:
This is a quick access into the internal menu system of the DSK unit. This button
enables the user to access the Threshold level of the menu system. This is similar to
pressing the SETUP button to access the menu system and then using the shaft
encoders to select the Threshold option from the DSK sub-menu. After pressing the
threshold button you may use the shaft encoders to cycle through the range from 4
Black to 1020 White. The SELF KEY is a hard key. All values from the key that fall
above the Key Threshold will be keyed from Fill. All values from the key that fall below
the Key Threshold will be keyed from Background. Press SELECT to accept the
changes or SETUP to escape without making any changes.
GAIN:
This is a quick access into the internal menu system of the DSK unit. This button
enables the user to access the Gain level of the menu system. This is similar to pressing
the SETUP button to access the menu system and then using the shaft encoders to
select the Gain option from the DSK sub-menu. After pressing the gain, the user may
adjust the range of values from 500 to 2000 (per thousand). This setting increases or
decreases the entire range of colour with respect to the key input. This will render the fill
as more or less pronounced respectively. Press SELECT to accept the changes or
SETUP to escape without making any changes.
MATTE:
This is a MATTE On/Off button. A lit LED indicates that the Matte is enabled. Matte
settings can be changed from the Matte menu option. Press the SETUP button and
scroll to the Matte menu item to make changes to the aspect ratio and other aspects of
the Matte.
GRATICULE:
A lit LED indicates that the graticules are ON. Graticules are only visible on the
preview output. Graticules are a SD feature only and not available on the HD version of
the DSK.
PRESET SAVE:
This is a quick access into the internal menu system of the DSK unit. This button
enables the user to access the PRESET SAVE level of the menu system. This is similar
to pressing the Setup button to access the menu system and then using the shaft
encoders to select the Save Preset option from the Preset sub-menu. After pressing the
PRESET SAVE button the user may adjust the value from 1 to 10 to store the preview
bus state into a storage file that can be recalled at a later time. This stored preset can be
triggered from automation, or recalled from the preset recall option of the preset sub-
menu. Press SELECT to accept the changes or SETUP to escape without making any
changes.
Page 4-4
Note:
Revision 1.4
Only the bypass output
DESKTOP CONTROL PANEL
Advertisement
Table of Contents
