Kyocera TASKalfa 7002i Service Manual page 1582

9-2 Firmware environment commands
The printer maintains a number of printing parameters in its memory. These parameters may be changed per-
manently with the FRPO (Firmware RePrOgram) commands.
This section provides information on how to use the FRPO command and its parameters using examples.
Using FRPO commands for reprogramming the firmware
The current settings of the FRPO parameters are listed as the optional values on the service status page.
Note: Before changing any FRPO parameters, print out a service status page, so you will know the parameter-
values before the changes are made. To return FRPO parameters to their factory default values, send the-
FRPO INIT (FRPO-INITialize) command. (!R! FRPO INIT; EXIT;)
The FRPO command is sent to the printer in the following sequence:
!R! FRPO parameter, value; EXIT;
Example: Changing emulation mode to PC-PR201/65A
!R! FRPO P1, 6; EXIT;
FRPO parameters
Items
Top margin
Left margin
Page length
Page width
PRESCRIBE compatible mode
Default pattern resolution
Default copy number
Page orientation
Default font
PCL font switching
Total host buffer size
FRPO
A1 Integer value in inch
A2 decimal value in 1/100 inch increments
A3 Integer value in inch
A4 decimal value in 1/100 inch increments
A5 Integer value in inch
A6 decimal value in 1/100 inch increments
A7 Integer value in inch
A8 decimal value in 1/100 inch increments
B0 0 to 255
B8 0: 300 dpi
1: 600 dpi
C0 1 to 999
C1 0: Portrait
1: Landscape
C2 Middle two digits of power-up font
C3 Last two digits of power-up font
C5 First two digits of power-up font
C8 0:HP compatible mode
32:Compatibility mode
H8 0 to 99 in units of the size defined by FRPO S5
9-2
Setting value
2WA/2NJ/2RK-1
Factory set-
ting
0
0
0
0
17
30
17
30
0
2 (100V)
0
1
0
0
0
0
0
5