Table of Contents
Advertisement
Electrical installation
8.3.3
Shielding connection to the front panel
8.3.4
Motor connector X9 with shielding connection
52
12/2010a
‚
S701...S724 (single channel STO) Instruction Manual
Remove the outside shroud of the cable and
the shielding braid on the desired core length.
Secure the cores with a cable tie.
Remove the outside shroud of the line on a
length from for instance 30mm without dama-
ging the shielding braid.
Strip all wires and fit wire end ferrules.
Use cable ties to attach the cable to the side
(1) or bottom (2) shroud of the servo amplifier,
securing the braided shield of the cable to the
shroud of the servo amplifier with a cable tie.
Alternatively you can use shield connection
terminal clamps (see accessories manual).
These hook into the bottom shroud and ensu-
re optimum contact between the shield and
the shroud.
Wire the plug-in terminal blocks as shown in
the connection diagram.
The motor cable shield is connected via the
bottom motor connector X9 (see below).
Strip the external cable sheath to a length of
approx. 120 mm, taking care not to dama-
ge the braided shield. Push the braided
shield (1) back over the cable and secure
with a rubber sleeve (2) or shrink sleeve.
Shorten all the wires apart from the
protective earth (PE) wire (green/yellow) by
about 20 mm so that the PE wire is now the
longest wire. Strip all wires and fit wire end
ferrules.
Secure the braided shield of the cable to the
shroud with a cable tie (3) and use a second
tie (4) to fasten the cable over the rubber
sleeve.
Wire the connector as shown in the
connection diagram. Plug in the connector
to the socket on the front of the S700.
Screw the connector in place. This
ensures that there is conductive contact
over a large surface area between the
braided shield and the front panel.
Kollmorgen
Advertisement
Table of Contents
