Fall Restraint; Final Process - Trane IntelliPak 1 with Symbio 800 Installation, Operation And Maintenance Manual

Fall Restraint

WARNING
Falling Off Equipment!
Failure to follow instructions below could result in
death or serious injury.
This unit is built with fall restraint slots located on
unit top that MUST be used during servicing. These
slots are to be used with fall restraint equipment that
will not allow an individual to reach the unit edge.
However such equipment will NOT prevent falling to
the ground, as they are NOT designed to withstand
the force of a falling individual.
The fall restraint is located approximately 3 feet from the
unit edge.
Figure 121. Fall restraint
Table 77. Unit data log
Complete Unit Model Number:
Unit Serial Number:
Unit "DL" Number ("design
special" units only):
Wiring Diagram Numbers (from
unit control panel):
-schematic(s)
-connections
Network ID (LCI/BCI):
RT-SVX072D-EN

Final Process

Record the unit data in the blanks provided.
FALL RESTRAINT
Service and Maintenance
151