Information; Factory Warranty Information; All Unit Installations; Additional Requirements For Units Requiring Disassembly - Trane IntelliPak 1 with Symbio 800 Installation, Operation And Maintenance Manual

Pre-Installation
Unit Dimensions and Weight Information
Table 1. Unit dimensions and weight information
Description
Unit dimensions, 20–75 ton (SAH_)
Unit dimensions, 90–130 ton
Roof curb weights
Center-of-gravity illustration and related dimensional data

Factory Warranty Information

Compliance with the following is required to preserve the
factory warranty:

All Unit Installations

Startup MUST be performed by Trane, or an authorized
agent of Trane, to VALIDATE this WARRANTY. Contractor
must provide a two-week startup notification and true start
date to Trane (or an agent of Trane specifically authorized
to perform startup).
On all IntelliPak 1 units, a Trane factory startup is an option
and provides maximized unit reliability and overall unit
performance in addition to preserving the standard factory
warranty.
Additional Requirements for Units
Requiring Disassembly
When a new fully assembled IntelliPak is shipped and
received from our Trane manufacturing location, and, for
any reason, it requires disassembly or partial disassembly,
which could include but is not limited to the evaporator,
condenser, control panel, compressor/motor, factory
mounted starter, or any other components originally
14
Air-Cooled Condenser
Figure 2, p. 18, Figure 3, p.
Figure 6, p. 22
Figure 7, p. 23
attached to the fully assembled unit, compliance with the
following is required to preserve the factory warranty:
• Trane, or an agent of Trane specifically authorized to
perform start-up and warranty of Trane® products, will
perform or have direct on-site technical supervision of
the disassembly and reassembly work.
• The installing contractor must notify Trane, or an agent
of Trane specifically authorized to perform start-up and
warranty of Trane® products, two weeks in advance of
the scheduled disassembly work to coordinate the
disassembly and reassembly work.
• Start-up must be performed by Trane or an agent of
Trane specifically authorized to perform start-up and
warranty of Trane® products.
Trane, or an agent of Trane specifically authorized to
perform startup and warranty of Trane® products, will
provide qualified personnel and standard hand tools to
perform the disassembly work at a location specified by the
contractor. The contractor shall provide the rigging
equipment, such as chain falls, gantries, cranes, forklifts,
etc., necessary for the disassembly and reassembly work
and the required qualified personnel to operate the
necessary rigging equipment. See
Clause," p. 156
Reference
19, Figure 4, p. 20, Figure 5, p. 21
"Warranty and Liability
for additional details.
RT-SVX072D-EN