Trane IntelliPak 1 with Symbio 800 Installation, Operation And Maintenance Manual page 141

Table 72. Supply fan VFD programming parameters
Description
Menu ID
0-01
Regional Settings
0-03
Operation
Display
0-06
[Hand on] - Key on
0-40
Motor Power [HP]
1-20
Motor Voltage (V)
1-22
Motor Frequency
1-23
Load and Motor Current (A)
1-24
Motor
Motor Nominal
1-25
Speed (RPM)
1-73
Motor Thermal
1-90
DC Hold / Preheat
2-00
DC Brake Current
Brakes 2-01
DC Brake Cut In
2-04
3-02
Reference (HZ)
3-03
Reference (HZ)
Reference 1
3-15
Reference /
Reference 2
3-16
Ramps
Reference 3
3-17
Ramp 1 Ramp Up
3-41
Ramp 1 Ramp
3-42
Down Time (S)
Motor Speed Low
4-12
Motor Speed High
4-14
Limits /
Warnings
Current Limit (%)
4-18
4-19
Frequency (HZ)
RT-SVX072D-EN
Language [0] English US
[1] North American
Set to applicable unit power supply
[102] 200-240V/60HZ for 208, and 230V/60HZ units
[122] 440-480V/60Hz for 460V/60Hz units
Grid Type
[132] 525-600V/60Hz for 575V/60Hz units
[12] 380-440V/50Hz for 380, and 415V/50Hz supply
For IT Grid (no ground connections) or Corner grounded Delta power supply systems, the applicable voltage/
Hz and IT-Grid or Delta should be selected.
[0] Disabled
LCP
Per Motor Nameplate HP
Per Motor Nameplate Voltage
Per Motor Nameplate Frequency
(HZ)
Per Motor Nameplate FLA
Per Motor Nameplate Rated Speed
Flying Start [1] Enabled
[4] ETR Trip1
Protection
[0] 0%
Current (%)
[0] 0%
(%)
[10] 10Hz
Speed (HZ)
Minimum Per Unit Nameplate - Evap Fan VFD Min Hz
Maximun Per Unit Nameplate - Evap Fan VFD Max Hz
[11] Local bus reference
Source
[0] No function
Source
[0] No function
Source
[30] 30s
Time (S)
[30] 30s
[22] 22 Hz for FC fans (Digit 14=1, 2, 3, 4, 5, 6, 7, 8, 9, A)
Limit [HZ] [15] 15 Hz for DDP Fan (Digit 14=B through Z)
See Table 1 below for value
Limit (Hz)
[100] 100%
Max Output [60] 60 Hz for FC Fan (Digit 14= 1, 2, 3, 4, 5, 6, 7, 8, 9, A)
[120] 120 Hz for DDP Fan (Digit=14 B through Z)
Service and Maintenance
Parameter Setting
141