Acceleration Measurement - Audi A7 2023 Owner's Manual

Driving information
> To start timing a new lap after driving a lap, se-
lect New lap in the menu. This starts timing
the next lap at the same time.
After completing a lap, the difference between
the last lap and the previous best lap time will be
indicated with a - or +.
Pausing timing and displaying a split time
» To take a break W, select Pause in the menu.
> To resume timing, select Resume in the menu.
» To display a split time, select Split time in the
menu. The split time @ appears for approxi-
mately ten seconds in the instrument cluster.
The current lap timing will continue running.
Canceling lap timing
The timing of the current lap will stop. The lap
time will be erased and will not be included in the
statistics.
» Select Cancel lap in the menu.
Resetting the time
» Select Reset lap times in the menu.
— A maximum of 99 lap times can be meas-
ured.
— If timing is paused, you can continue it later
even if you switch the ignition off.
— Saved lap times cannot be individually de-
leted from the total results.
—The saved lap timer values will remain after
switching the ignition off.
Lap statistics
Applies to: vehicles with lap timer
Displaying lap statistics
You can display the number of laps driven #®, the
fastest lap +, the slowest lap -, and the average
time @ in the instrument cluster.
» Select in the instrument cluster: Vehicle func-
tions tab > &) button > Lap statistics.
1) Not available in all countries
128
» Turn the thumbwheel down or up to display the
individual lap times.
» To return to the lap timing that was started, se-
lect the =) button > Lap times.
Resetting lap statistics
Requirement: the lap statistics menu must be
displayed.
» To reset the lap statistics, press and hold the
left thumbwheel until the message No lap
times have been recorded yet. appears.
The lap statistics list the lap times for the last
30 laps. The fastest and slowest lap times out
of up to 99 measured laps are also displayed.
Acceleration
measurement!)
Introduction
Applies to: vehicles with acceleration measurement
With the acceleration measurement, you can
measure the time that you need to reach a specif-
ic speed/distance. For the best possible measure-
ment readings, Audi recommends limiting the
ESC or switching it off. Keep in mind that the en-
vironmental conditions and tire properties can af-
fect the results of the measurement.
Opening the acceleration measurement
» Select in the instrument cluster: vehicle func-
tions tab > ) button > Acceleration measure.
Your focus should always be on driving your
vehicle safely. As the driver, you have com-
plete responsibility for safety in traffic. Only
use the acceleration measurement function
on closed courses to reduce the risk of acci-
dents.