Audi A7 2023 Owner's Manual page 52

Opening and closing
systems or house lights from inside your vehicle.
These functions are operated in the MMI. Multi-
ple receivers can be programmed, which can con-
trol the functions of up to eight!) hand-held
transmitters.
— When operating or programming the garage
door opener, make sure that no people or
objects are in the area immediately sur-
rounding the equipment. People can b
jured or property can be damaged if struck
when closing.
~Do not allow yourself to be distracted from
traffic by the viewing and operating the dis-
plays.
— Ifyou sell your vehicle, reset all settings to
the factory default settings > page 232.
—The system complies with United States FCC
regulations and ISED regulations
page 313.
Before you program your system to the ga-
rage door opener, first check the compatibili-
ty:
— Ask an authorized Audi dealer or authorized
Audi Service Facility or check at www.
homelink.com. You can also find more infor-
mation about HomeLink there.
= You can display information about Home-
Link (compatibility level/status/country
code/HomeLink generation) in the MMI:
— Select on the home screen: VEHICLE > Set-
tings & Service > Garage door opener > ©.
Applies to: vehicles with garage door opener
Requirements: the remote control transmitter
must be programmed © page 50, Program-
ming, the vehicle must be within range of the
system, and the ignition must be switched on.
D The possible number of hand-held transmitters depends
on the equipment.
50
There are multiple options to open or close the
system (such as the garage door).
» If you have only programmed one remote con-
trol transmitter, press the 7 button on the
lower display. Or
> If you have programmed multiple remote con-
trol transmitters, press the 7@ button on the
lower display and then press the respective sys-
tem button. Or
» Applies to: vehicles with programmable steer-
ing wheel button: If you have configured the
programmable steering wheel button, press
the 2K button © page 37. Or
» Applies to: vehicles with location pairing: If you
have programmed Location pairing, press the
button for this in the upper display (notification
center > page 23). As you approach the system,
the button is displayed on the MMI.
If transmission was successful, the message:
Send to: XXX will appear.
Applies to: vehicles with garage door opener
You can program both fixed code and rolling code
systems in the MMI using the procedure that is
described.
Requirement: the ignition must be switched on.
Programming the system
Applies to: MMI
Requirement: the hand transmitter must be
present and the vehicle must be within range of
the system (such as the garage door) that you
would like to program.
» If you are programming the garage door opener
for the first time, press the @ button on the
lower display. Follow the instructions in the up-
per display. Or
> If you would like to program other systems, se-
lect on the home screen: VEHICLE > Settings &
Service > Garage door opener. Select the de-
sired button: @). Follow the instructions in the
MMI.