Audi A7 2023 Owner's Manual page 297

Emergency assistance
(50 km), then transport the vehicle on a
special carrier.
— If the vehicle is towed by a tow truck at the
axle that is not permitted, this can cause se-
vere damage to the transmission.
~The vehicle must not be tow started for
technical reasons.
'the power supply is interrupted, then it
will not be possible to move the selector
lever out of the "P" position. The parking
lock must be released using the emergency
release before towing the vehicle
© page 98.
— Switch Audi pre sense* off > page 757 when
loading the vehicle onto a vehicle carrier,
train, ship, or other type of transportation,
or when towing the vehicle. This can prevent
an undesired intervention from the pre
sense* system.
— Follow the local legal regulations for tow-
ing.
Read and follow the important information un-
der © page 294.
Preparations
» Only secure the towing cable or tow bar at the
designated towing loops > page 295,
page 296.
» Make sure the towing cable is not twisted. Oth-
erwise it could disconnect from the towing loop
while towing.
» Switch the emergency flashers on in both
vehicles > page 57. However, do not do this if it
prohibited by law.
Towing vehicle (front)
» Only start to drive when the towing cable is
taut.
» Press the brake pedal very carefully.
» Avoid sudden braking or driving maneuvers.
Vehicle being towed (rear)
» Make sure the ignition is switched on so that
the steering wheel is not locked and so that you
can use the turn signals, the horn, and the
windshield wipers if needed © /\.
» Switching it off before the vehicle has stopped
may impair the function of the brake booster
and power steering. You would then need to
use more force to steer and brake the vehicle.
» Release the parking brake © page 104.
» Select the "N" selector lever position.
» Make sure the towing cable is always taut.
— Never tow a vehicle using a tow bar or tow-
ing cable if the vehicle does not have electri-
cal power.
~ If the vehicle runs out of power while i t i s
being towed, stop towing the vehicle imme-
diately and consult an authorized Audi deal-
er or qualified repair facility.
Fig. 173 Front bumper: installing the towing loop
The threaded opening for the towing loop is lo-
cated on the right side of the front bumper.
» Remove the towing loop from the vehicle tool
kit @ page 286.
» Press the cap inward with brief, strong pressure
© fig. 173. The cap will loosen from the bump-
er.
» Tighten the towing eye as far as it will go into
the mount. Use a suitable object to tighten the
towing eye completely and securely in the
mount.
295