Audi A7 2023 Owner's Manual page 132

Dri
ing information
When activated, the $1 tab appears in the instru-
ment cluster.
» Select in the instrument cluster: 1 tab
(6) Tips
When the night vision assist tab is selected in
the instrument cluster and the low beams are
switched off, the thermal image display dis-
appears only after you have exited the tab.
Marking and warning
Applies to: vehicles with night vision
Fig. 87 Instrument cluster: pedestrian marking and warn-
ing
Highlighting detected pedestrians and wild
animals
Within the limits of the system, the night vision
assist can detect pedestrians and wild animals
that are between approximately 32 feet (10 m)
and 295 feet (90 m) in front of the vehicle and
within the detection zone. Animal recognition is
not active within highly developed areas. The sys
tem only detects large wild animals such as deer.
When it is dark outside and the low beams are
switched on, detected objects are marked in yel-
low @ within the limits of the system.
Pedestrian and wild animal warning
This system limits are based on the vehicle speed
and steering angle. Pedestrian and wild animal
warning encourages you to pay more attention.
If there are pedestrians or wild animals in front
of your vehicle that could pose a danger, the sys-
tem will direct your attention to this.
130
~ Pedestrians or wild animals are highlighted in
red in the instrument cluster @ and the [ij or
Bi symbol turns on @.
~When the head-up display" is switched on, the
additional indicator fl or [i appears.
~A chime will sound if something is detected.
~ If the night vision assist thermal image is re-
placed by another display (such as the on-board
computer), the red [fj or J indicator light will
appear if there is a pedestrian or wild animal
warning.
The Siti symbol will appear when pedestrian and
wild animal detection is not available.
Marking light*
To direct the driver's attention to a pedestrian,
the headlights can flash on the pedestrian when
there is a pedestrian warning.
This occurs at speeds above approximately
35 mph (60 km/h) if you are outside of illuminat-
ed areas and no detected vehicles are shown. The
marking light is not used for wild animals. The
high beam assistant" controls the marking
light*> page 54.
Adjusting the contrast
Applies to: vehi n assist
Requirement: the night vision assist must be
switched on and the $1 tab must be displayed.
> Applies to MMI: Select on the home screen: VE-
HICLE > Driver assistance > () > Night vision
assist.
> To set the desired contrast, move the slider.
Messages
Applies to: vehicles with night vision assist
The following messages may appear depending
on the vehicle equipment:
A Night vision assist: currently unavailable.
See owner's manual
The system is not functioning correctly at the
time, so it has been switched off. If the malfunc-
tion persists, drive immediately to an authorized
Audi dealer or authorized Audi Service Facility to
have the malfunction repaired.