Audi A7 2023 Owner's Manual page 57

Lights and Vision
> To deactivate the high beams manually, pull
the lever back @) > page 54, fig. 37. The high
beam assistant is deactivated.
Operating the headlight flasher
» To operate the headlight flashers, pull the lever
back @ page 54, fig. 37. If the high beam
headlights are not switched on, the high beam
assistant will remain activated.
— Observe the safety precautions and note the
limits of the assist systems, sensors, and
cameras page 119.
—High beam assistant is only intended to as-
sist the driver. The driver is responsible for
controlling the high beam headlights and
adjusting them to match the lighting and
visibility conditions.
—High beams can cause glare for other driv-
ers, which increases the risk of an accident.
For this reason, only use the high beams or
the headlight flasher when they will not cre-
ate glare for other drivers.
Adhere to any local applicable regulations
when using the lighting equipment, for exam-
ple in regard to reducing glare for other driv-
ers. The driver is always responsible for adher-
ing to the regulations applicable in the coun-
try where the vehicle is being operated.
Laser lighting
Applies to: vehicles with laser lighting
Fig. 38 Headlights: label
The laser lights increase the range of the head-
lights.
An additional module integrated in the headlight
converts a blue laser light into a white light using
a luminescent material.
Activating or deactivating laser lights
Requirement: the AUTO light function must be
set, and the high beam assistant and the laser
lights must be switched on in the MMI
= page 56.
The high beam is controlled by the high beam as-
sistant. The laser lights switch on shortly after
the LED high beams are switched on.
» To activate the high beam assistant, tap the
lever forward @ = page 54, fig. 37. The
dicator light will appear in the instrument clus-
ter display and the high beams will be switched
on or off automatically.
in-
The laser lights are switched on at speeds above
approximately 44 mph (70 km/h) when the high
beams are switched on. The fi indicator light
will turn on if the high beams are switched on. >
55