Water Drain Connection - Smeg WD1050 Operating Instructions Manual

5.6. WATER DRAIN CONNECTION

This machine has just one outlet hose.
The internal diameter of the hose is ½" so it can be connected to any standard ½"
hose adapter.
General rules for installing outlet
The washing water outlet hose must be placed with its curved section hooked onto the
edge of a sink or waste pipe. A drain pipe with siphon should be used.
The following precautions should be observed during installation:
• As the water drain temperature may reach about 93°C the end of the outlet hose
must be connected firmly to the drain by using clamps.
• The outlet hose must not have any tight bends liable to obstruct the flow;
• The end of the outlet hose must not be placed either more than 80cm or less than
65 cm above the surface on which the machine is installed;
• The end of the hose must under no circumstances be immersed in water;
• The internal diameter of the waste pipe must be at least Ø 40 mm;
• We recommend installing a waste pipe of diameter 50 mm;
• Don't use waste pipe extensions.
WARNING
The drain connection must comply with international standards.
Our company will accept no liability for pollution caused by the
machine.
WD1050
fig. 4 – 65 cm < A < 80 cm
.
12/04/2010 Pag. 13