Reer MOSAIC M1 Installation And Use Manual page 257

MODULAR SAFETY INTEGRATED CONTROLLER MOSAIC
Template Stimuli: used to save the template file with the desired name and disk location.
Figure 132
This file will contain the names of the signals as shown in the diagram, Now
you may use a text editor to enter the status of the input signals at a given moment in time
Figure 133
as well as the duration of the simulation and the time step to be used, .
Figure 132 – Template file immediately after saving Figure 133 –Example of complete template file
Simulation with Stimuli: used to load a template file (suitably completed) and, once
loaded, to immediately start the simulation.
At the end of the simulation, a graph is displayed with the resulting signals.
Load simulation: used to load a previously completed simulation, provided at least one
has been saved.
Traces visibility: used to select the traces (signal waveforms) to be displayed in the graph.
Figure 134
When you press this key, it opens a pop-up window as shown in from which
you can add or remove traces to or from the graph.
8540780 • 25/01/2023 • Rev.43 257