Reer MOSAIC M1 Installation And Use Manual page 118

MODULAR SAFETY INTEGRATED CONTROLLER MOSAIC
HOST: Type in this field the IP address of the MOSAIC M1S COM module to be
connected.
➔
HOST: MSD will show the last 10 IP addresses entered by the user.
Figure 77 - Host selection
DEVICE SCANNING: By clicking on the word "Device Scanning" MSD will start
searching for MOSAIC M1S COM devices in the Local Area Network. If devices are
found then a list is displayed in the text box. It is shown each device IP together
with its MAC address.
The IP address of the PC where MSD is running is displayed near the word Network.
Figure 78 - Device scanning
118 8540780 • 25/01/2023 • Rev.43