Installing The M.2 Ssd Module - Dell EMC PowerEdge R450 Xeon 4309Y Installation And Service Manual

Figure 88. Removing the M.2 SSD module
Next steps
Replace the M.2 SSD module.

Installing the M.2 SSD module

Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
3. Remove the air shroud.
4. Remove the BOSS card
NOTE: The procedure to remove the BOSS card is similar to the
Steps
1. Connect the M.2 SSD module to the connector on the BOSS card.
2. Place the retention strap on the M.2 SSD module, and tighten the screw to secure the module.
Safety instructions.
Before working inside your system.
removing an expansion
Installing and removing system components
card.
95