Table of Contents
Advertisement
7. Observe and disconnect the drive backplane cables from the connector on the system board and backplane.
NOTE:
Refer to
cable routing
NOTE:
To avoid damaging the backplane, remove the disconnected backplane cables from the cable routing clips.
NOTE:
Route the cable properly when you replace it to prevent the cable from being pinched or crimped.
Steps
1. Align the slots on the drive backplane with the guides on the system.
2. Slide the drive backplane into the guides and lower the backplane until the blue release tab clicks into place.
Figure 49. Installing the drive backplane
Next steps
1. Connect the drive backplane cables to the connectors on the system board and backplane.
2.
Install the
drives.
3. If required,
install the rear mounting front PERC
4.
Install the cooling fan cage
5. If removed,
install the air
6. Follow the procedure listed in
Side wall brackets
Removing the side wall bracket
There are two side wall brackets on either side of the system. The procedure to remove is similar.
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. If installed,
remove the air
4.
Remove the cooling fan cage
section for more information.
module.
assembly.
shroud.
After working inside your
Safety
instructions.
Before working inside your
shroud.
assembly.
system.
system.
Installing and removing system components
89
Advertisement
Table of Contents
