Service Window - decon JW Smart Tune Operation Manual

Servo model
5 Operating Servo model
5.8

Service Window

Depending on the serial number used during installation, this menu may be inaccessible. Contact your
software provider if you need to access this menu.
5.8.1 Displayed Items
1
2
3
4
5
1 Model Information of the Left and Right Wheel Units
This is read-only data. The information cannot be replaced.
2 Torque Sensor Signal Characteristics of the Left and Right Wheel Units
Selecting [Tool] > [Adjust right handrim sensor neutral position] or [Adjust left handrim sensor
neutral position] from the menu bar displays the loaded numerical values.
Adjusting Torque Sensor Characteristics"
3 Number of Springs on the Left and Right Wheel Units
This area is used to select the number of springs on the left/right wheel unit from the drop-
down list.
4 Driving Distance and Time of the Left and Right Wheel Units
This is read-only data. The information cannot be replaced.
5 Product serial No. of the Left and Right Wheel Units
Normally, this is read-only data.
Selecting [Communication] > [Enable to change product serial No.] from the menu bar allows
you to replace the Product serial No.. P.63 "5.8.3 Enable to change product serial No."
6 [Open] Icon
This icon opens the data files saved to the PC. P.48 "5.4.2 Recalling Setting Data"
The same operation can be performed by selecting [File] > [Open] from the menu bar.
6 7 8 9
61
10
P.63 "5.8.4