decon JW Smart Tune Operation Manual page 56

Servo model
5 Operating Servo model
5.5.6 Read backup driving parameters
Selecting [Communication] > [Read backup driving parameters from right unit] from the menu bar
loads the driving parameters of the right and left wheel units from the right wheel unit.
Selecting [Read backup driving parameters from left unit] similarly loads the parameters of both
units from the left wheel unit.
This feature is used when you want to replace the substrate of one side only by restoring the
parameters from the substrate not to be replaced.
5.5.7 Balance adjustment auto-calculation
When recommended settings are calculated, the Coasting Distance is changed to standard
(1.0), and the Response Level (Balance Adjustment) setting is calculated based on automated
diagnostic results.
This operation is simultaneously applied to both the [Mode 1] and [Mode 2] tabs.
1
The parameters and automated diagnostic results are loaded by selecting
[Tool] > [Balance adjustment auto-calculation] from the menu bar.
2
Enter the numerical value when the Distance Between Wheels input screen
appears.
56