decon JW Smart Tune Operation Manual page 38

Joystick model
4 Operating Joystick model
4.7.4 Enable to change product serial No.
Selecting [Communication] > [Enable to change product serial No.] from the menu bar allows you
to replace the Product serial No. of the left and right wheel units ([Basic information1] tab), as well
as of the propulsion controller ([Basic information2] tab).
Selecting [Communication] > [Disable to change product serial No.] locks the Product serial No.
areas, not allowing replacement.
4.7.5 Error Codes
When reading failure occurs in the Service window, an error code may appear in the lower part of
the error message. Check the details of the code using the table below.
Error Code
0x80000000
0x80000001
0x80000002
0x80000003
0x80000004
0x80000005
0x80000006
0x80000007
0x80000008
0x80000009
0x8000000a
Timeout
Cancellation
Not Connected
Transmission Failure
Sequence Error (incoming message check)
Size Error (incoming message check)
Checksum Error (incoming message check)
SUB File Read Error (currently not in use)
Unidentified Error (COM not found, etc.)
Incorrect Data Quantity (when receiving a large quantity of data)
Other than the above
38
Probable Cause