Changing The Settings - decon JW Smart Tune Operation Manual

Servo model
5 Operating Servo model
5.3

Changing the Settings

1
Load the setting data of the wheelchair using the icon or the menu bar, with the line
status displayed in blue (connected).
Skip steps 1 and 2 if a connection is established and reading is performed on window
startup.
[Read] Icon
2
Verify the state of the wheelchair following the instructions in the confirmation
message, then press [OK]. If an error message appears, check the contents of the
message and perform the operation once again.
Read Confirmation Message
Error example: Left and right wheel unit parameter mismatch
[Communication] Menu
44