Setting The Communication Port - decon JW Smart Tune Operation Manual

Servo model
5 Operating Servo model
Pressing [Cancel] will start the window without connecting. Select the communication
port and read the wheelchair's data manually. P.42 "5.2 Setting the Communication
Port"
5.2

Setting the Communication Port

In the default settings of JW Smart Tune, once the menu window starts, the confirmation window is
displayed for automatic reading of the wheelchair's data, and a connection is established.
To disable reading on startup, go to [Communication] and uncheck [Auto-read the wheelchair driving
parameters when ST connected].
1
Select [Driving Parameters] or [Service] from the Main Menu.
2
From the menu bar, select [Communication] > [Select COM Port].
3
When JW Smart Tune is run for the first time after installation, the port number will
appear blank. Select the port number connected to the wheelchair from the drop-
down list, then press [OK].
When multiple port numbers are displayed in the drop-down list, open the [Control Panel]
of your PC, and check the number connected to the wheelchair using Device Manager.
Once the settings are configured, the window subsequently opens with the port
number set to the port with which communication was performed last.
42