Renesas E1 User Manual page 32

E1/E20 Emulator
(2) Click on the [START] button to start the self-checking program.
If the user interface cable has not been connected to the self-checking connector, the following message is
displayed:
"Please connect the user interface cable to the self-check connector on E1 or E20 in a correct direction."
Check that the user interface cable is connected to the self-checking connector in the right direction as shown in
Figure A.1, and click on the [OK] button. This starts the self-checking program.
If the user interface cable has not been connected to the self-checking connector when the [OK] button is clicked
on, "FAIL" is displayed on the screen (see figure below). Correctly connect the cable to the self-checking
connector and click on the [START] button again to start the self-checking program.
R20UT0398EJ0401 Rev.4.01
Mar 15, 2016
Figure A.3 Checking the Connection
Figure A.4 [FAIL] at the Start of Self-Checking
(without the Cable Connected to the Self-Checking Connector)
Appendix A
Page 32 of 40