Preparations For Self-Checking - Renesas E1 User Manual

E1/E20 Emulator
A.2 Preparations for Self-Checking
(1) The following items are required to execute the self-checking program.
 E1 or E20 emulator
 USB interface cable (included in the package)
 User interface cable (included in the package)
 Installation medium (included in the package)
 Host computer
The emulator software and USB driver must also be installed on the host computer in advance.
(2) Open the lid of the self-checking connector on the emulator. Then connect the user-side connector and self-
checking connector via the user interface cable.
ACT
Self-checking
connector
Lid
Figure A.1 Connecting the User Interface Cable (for the E1 and E20)
Insert the user interface cable firmly into the self-checking connector. If the connection is loose, the
result will be "FAIL".
(3) Start up the host computer. Connect the host computer and the emulator via the USB interface cable and turn
on the power for the emulator. The timing with which the supply of power starts differs with the emulator.
E1: The supply of power starts when the USB interface connector is connected.
E20: The supply of power starts when the power switch is turned on after the USB interface cable has been
connected.
R20UT0398EJ0401 Rev.4.01
Mar 15, 2016
E1 Emulator
User-side connector
VCC
RESET
RUN
SELF CHECK
ACT
Self-checking
connector
Lid
CAUTION
Appendix A
E20 Emulator
User-side connector
VCC
RESET
RUN
SE
Page 30 of 40