Renesas E1 User Manual page 22

E1/E20 Emulator
38-pin connector
2-5767004-2
Figure 2.5 Connecting the User-System Interface Cable to the User System when the 38-Pin
Connector is in Use with the E20
Limit to the height on connector periphery:
For a case where the E20 emulator is connected to a 38-pin connector:
When designing the layout of a user board with a 38-pin connector, reduce cross-talk noise etc. by
keeping other signal lines out of the region where the connector is situated. As shown in Figure 2.5,
an upper limit (5 mm) applies to the heights of components mounted around the connector on the
user system (indicated by "area with limit on mounted components" in the figure).
R20UT0398EJ0401 Rev.4.01
Mar 15, 2016
38-pin user-system interface cable
5 mm
User system
37
38
: Area with limit on mounted components
Connector (top view)
CAUTION
30 mm
1
2
Page 22 of 40
Setup