Section 2 Connection Procedures; Connecting User System Interface Cable To Emulator Station - Renesas H8SX/1582 User Manual

2.1

Connecting User System Interface Cable to Emulator Station

Observe the precautions listed below. Failure to do so
will result in a FIRE HAZARD and will damage the user
system and the emulator product or will result in
PERSONAL INJURY. The USER PROGRAM will be LOST.
1. Always switch OFF the user system and the emulator
product before the USER SYSTEM INTERFACE CABLE
is connected to or removed from any part. Before
connecting, make sure that pin 1 on both sides are
correctly aligned.
2. The user system interface cable dedicated to the
emulator must be used.
To connect the cable body to the emulator station, follow the instructions below.
1. Make sure the user system and emulator station are turned off.
When connecting or removing the user system interface
cable, apply force only in the direction suitable for
connection or removal, while making sure not to bend or
twist the cable or connectors. Otherwise, the connectors
will be damaged.

Section 2 Connection Procedures

WARNING
CAUTION
Section 2 Connection Procedures
Rev. 3.00 Sep. 08, 2008 Page 3 of 18
REJ10J1396-0300