Renesas E1 User Manual page 20

E1/E20 Emulator
(2) A connector to the user-system interface cable must be installed on the user system. Table 2.1 shows the
recommended connector for the emulator.
Table 2.1 Recommended Connector
Connector
14-pin connector
38-pin connector
(3) For the pin assignments of the connector, refer to the separate MCU-specific manual for the emulator.
(4) Connect one end of the user-system interface cable to the emulator and the other end to the connector on the
user system as shown in Figures 2.3, 2.4, and 2.5.
Figure 2.3 Connecting the User-System Interface Cable to the User System when the 14-Pin
Connector is in Use with the E1
Notes on connector insertion and removal:
When connecting or disconnecting the user-system interface cable and the emulator or user system,
grasp the connector cover at the end of the cable. Pulling the cable itself will damage the wiring.
R20UT0398EJ0401 Rev.4.01
Mar 15, 2016
Type Number
7614-6002 3M Japan Limited
2514-6002 3M Limited
2-5767004-2 Tyco Electronics Japan G.K.
14-pin user-system interface cable
Pin 2
Correct example
Manufacturer
14-pin straight type (Japan)
14-pin straight type (other countries)
38-pin type
Pin 1
CAUTION
Specifications
14-pin connector
7614-6002 or
2514-6002
User system
Incorrect example
Page 20 of 40
Setup