Section 2 Connecting The Emulator To The User System; Connecting The Emulator To The User System; Connecting The Emulator To The User System By Using The Ev-Chip Unit; Connecting The Ev-Chip Unit To The Emulator - Renesas E200F User Manual

Section 2 Connecting the Emulator to the User System

2.1

Connecting the Emulator to the User System

When the emulator is connected to the user system, use the optional EV-chip unit, user system
interface board, and trace cable.
2.2 Connecting the Emulator to the User System by Using the EV-chip
Unit
The following describes how to connect the emulator to the EV-chip unit, external bus trace unit,
emulation memory unit, trace cable, and user system interface board.
2.2.1

Connecting the EV-chip Unit to the Emulator

• Open the cover of TRACE I/F on the side of the main unit case.
• Connect the trace cable to the EV-chip unit as shown in figure 2.1.
Section 2 Connecting the Emulator to the User System
Rev. 4.00 Feb. 18, 2009 Page 7 of 64
REJ10J1662-0400