Renesas E1 User Manual page 36

E1/E20 Emulator
In the case of failure, the word "FAIL" is displayed, followed by an error message in the center of the window.
Table A.1 lists the error messages.
Clicking on the [LOG] button opens the file selection dialog box. Specify the location where you want the results
of self-checking to be saved. The results of self-checking are saved as a text file.
Table A.1 Error Messages
Message
The E1/E20 self-check has failed.
Please connect the user interface cable with
the self-check connector in a correct direction.
An error occurred during USB I/O processing.
If the FAIL is displayed in the other error, please request the repair because the product is defective.
R20UT0398EJ0401 Rev.4.01
Mar 15, 2016
Figure A.11 Display for an Error Found in Self-Checking
The user interface cable was connected to the user system at
the time the self-checking program was started or there is a
fault in the emulator.
If the fault falls under the warranty conditions given in section 7,
"Maintenance and Warranty", we will correct the fault or replace
the product for free. Correction or replacement in other cases
incurs a fee.
Correctly connect the user interface cable to the self-checking
connector before starting the self-checking program.
The USB interface cable was disconnected from the emulator
during self-checking or there is a fault in the emulator. Connect
the USB interface cable and restart the self-checking program.
If the error recurs, it is due to a fault in the emulator.
Description
Page 36 of 40
Appendix A