Table of Contents
Advertisement
E2, IE850A
3.Procedure for Connecting the Emulator to the User System
Connect the E2 emulator to the user system and turn the power on and off by following the procedures below.
For the procedure for connecting the IE850A to the user system, refer to the IE850A Emulator User's Manual.
3.1
When a separate power supply is used for the user system
<When using the emulator>
(1) Check the power is off.
Check that the user system is turned off.
(2) Connect the user system.
Connect the emulator and the user system with a user-system interface cable.
(3) Connect the host machine and turn on the emulator.
Connect the emulator and the host machine with a USB interface cable. The emulator is turned on by
connecting the USB interface cable.
(4) Turn on the user system.
Turn on the user system.
(5) Launch the debugger.
Launch the debugger.
<When finished using the emulator>
(1) Close the debugger.
Close the debugger.
(2) Turn off the user system.
Turn off the user system.
(3) Turn off the emulator and disconnect the emulator.
Disconnect the USB interface cable from the emulator. The emulator is turned off by disconnecting from
the USB interface cable.
(4) Disconnect the user system.
Disconnect the user-system interface cable from the user system.
Notes on the User System Power Supply:
While the power of the user system is on, do not turn off the host machine or unplug the USB
interface cable.
The user system may be damaged due to leakage current.
R20UT4140EJ0300 Rev.3.00
Oct.09.20
3. Procedure for Connecting the Emulator to the User System
CAUTION
Page 17 of 41
Advertisement
Table of Contents
