Table of Contents
Advertisement
The following features are common to all, or in some cases, most of the available 2D
symbologies. Default settings are indicated at each feature/option with a green arrow.
Also reference
standard factory settings. That section also provides space to record any custom set-
tings needed or implemented for your system.
To set most features:
1. Scan the ENTER/EXIT PROGRAMMING bar code at the top of applicable program-
2. Scan the correct bar code to set the desired programming feature or parameter.
3. If additional input parameters are needed, go to Appendix D, Keypad, and scan the
Complete the programming sequence by scanning the ENTER/EXIT PROGRAMMING bar
code to exit Programming Mode.
186
GRYPHON™ GFS4500
2D GLOBAL FEATURES
Appendix C, Standard Defaults
ming pages.
You may need to cover unused bar codes on the page, and possibly the facing
page, to ensure that the reader reads only the bar code you intend to scan.
appropriate characters from the keypad.
NOTE: Additional information about many features can be found in the
"References" chapter.
If you make a mistake before the last character, scan the CANCEL bar code
to abort and not save the entry string. You can then start again at the
beginning.
for a listing of the most widely used set of
Advertisement
Table of Contents
