Table of Contents
Advertisement
SETUP
INTERFACE SELECTION
Upon completing the physical connection between the reader and its host, proceed
directly to "
the interface type the scanner is connected to (for example: RS-232, USB, etc.) and scan
the appropriate bar code in that section to select your system's correct interface type.
The reader, depending upon the model, will support one or more of the following sets
of host interfaces:
•
•
•
•
•
•
•
•
CONFIGURING THE INTERFACE
Scan the programming bar code from the following section which selects the appropri-
ate interface type to match the system the reader will be connected to. Next, proceed to
the corresponding chapter in this manual (also listed in the table) to configure any
desired settings and features associated with that interface.
Table 1 - Available Interfaces
Select USB-OEM
1. Not available for GFS4520
10
GRYPHON™ GFS4500
Configuring the Interface" on page 10
USB (Keyboard, COM, OEM)
USB Composite (Keyboard + COM)
USB HID POS
USB Toshiba TEC
1
RS-232 STD
1
RS-232 WN
1
RS232 OPOS
Datalogic Magellan Scanners' specific interface
NOTE: Unlike some other programming features and options, interface
selections require that you scan only one programming bar code label. DO
NOT scan an ENTER/EXIT bar code prior to scanning an interface selection
bar code. Some interfaces require the reader to start in the disabled state
when powered up. If additional reader configuration is desired while in this
state, pull the trigger and hold for 5 seconds. The reader will change to a
state that allows programming with bar codes.
USB-OEM
NOTE:
If you erroneously read the USB-OEM interface selection code, it is
required to press and hold the trigger to unlock the reader. Then read the correct
interface bar code. This will work only at power-up. Please reconnect the reader
if the unlock is not successful.
for information and programming for
USB-OEM
(can be used for OPOS/UPOS/JavaPOS)
$P,HA45,P
Advertisement
Table of Contents
