Selecting The Interface Type; Interface Selection; Configuring The Interface - Datalogic PowerScan PD9630-SR Quick Reference Manual

SELECTING THE INTERFACE TYPE

Upon completing the physical connection between the
reader and its host, proceed directly to the Interface
Selection paragraph below, to program the reader for the
interface type it is connected to (for example: RS-232,
Keyboard Wedge, USB, etc.). Scan the appropriate bar
code to select your system's correct interface type.

Interface Selection

All models are multi-interface and support RS-232, USB,
Ethernet and Keyboard Wedge. Information and program-
ming options for each interface type are provided in this
section. For defaults and additional information associated
with each interface, proceed to the corresponding chapter
in the PowerScan™ 9600 Family PRG.

CONFIGURING THE INTERFACE

Scan the appropriate programming bar code to select the
interface type for your system.
NOTE: Unlike some other programming features and
options, interface selections require that you scan
only one programming label. DO NOT scan an
ENTER/EXIT label prior to scanning an interface
selection label.
Some interfaces require the scanner to start in the
disabled state when powered up. If you read one of
these interface selections by mistake, or if addi-
tional scanner configuration is desired while in this
state, pull the trigger and hold for 5 seconds. The
scanner will change to a state that allows reading
programming labels.
This procedure is allowed only once after the reader
is powered up. If it is necessary to repeat the pro-
cedure, you must cycle power to the reader before
repeating.
Selecting the Interface Type
QUICK REFERENCE GUIDE
7