Table of Contents
Advertisement
G4-504HD2a User Guide
GND
IGNITION
POSITIVE
Sensor Cable
The sensor cable CAB000383 and serial cable CAB000382 connect to the back of the device.
▪
The sensor portion of the cable is 5 metres sheathed together. Wires are colour coded and
labelled with its corresponding Sensor number.
There is a 4 pin flat Molex connector for attaching a Driver Alert Button or Alert Panel.
▪
ICD
The ICD connector is used to connect an optional ICD2 touch screen panel to the device. The
▪
panel can be used for configuring the recorder, configuring the IP camera, viewing live video
and playing back video. CAB000391 is used to connect the ICD Panel to the recorder.
GPS
If this option is included, a GPS module must be installed and attached to embed the vehicle
▪
location and speed into the video. The GPS module must be fitted on the outside of the vehicle
with its orientation pointing upwards.
9.3
Instructions for Setting Up the System
The G4-504HD2a is capable of recording up to 4 Analog/Analog HD and 1 digital IP camera
simultaneously. The 4 Analog/Analog HD cameras are connected using CAB000310 to the back of the
recorder. The single digital IP camera is connected using CAB000377 6 pin aviation to RJ45 adapter
connector.
Hardware Installation
(A) (Black)
Connect to the negative terminal of the battery, -12V.
Typically, grounds are established in the fuse panel, and
installers would need to connect there.
(B) (Yellow)
Connect to the vehicle ignition, +12V, signal required to
activate the device. Ensure that the provided 3 AMP
fuse is used. Ignition is obtained from the "cold" side
of the solenoid.
(C) (Red)
Connect to the positive terminal of the battery, +12v.
Ensure that the provided 15 AMP inline fuse is used. +12V is
obtained from the "hot" side of the solenoid, or the cables that
connect directly to the battery from the fuse panel
138 of 151
Advertisement
Table of Contents
