Table of Contents
Advertisement
G4-504HD2a User Guide
Back to Previous: Click the ( Cancel ) button to return to the previous screen without saving.
▪
Configuring the G4-504HD2a
Linkage
Click the ( Setup ) button under Linkage to go
to the Linkage setup screen. This sets up the
video display, recording and snapshot options
associated with this alarm.
The Linkage setup screen enables you to
configure the following options:
Channel – checkboxes which allow you
▪
to select any combination of the
camera channels to be included in the
display and recording.
Post Recording – drop list which
▪
allows you to select the duration for
which video will continue to be
recorded when the alarm is triggered.
Lock – checkbox, if selected will mark
▪
the recorded video associated with this
alarm as locked video.
Linkage IO Output – checkboxes, if
▪
enabled, the device will send a signal
to the selected IO output lines.
Output Delay Time – numeric text
▪
field to set the delay time for the IO
output (in seconds).
Linkage Screen – drop list to select the
▪
options to display the video from the
selected cameras on-screen when the
alarm occurs.
None : Not displayed.
Single : Display 1 camera.
Quad : Display 4 cameras.
If Single (1x1) or Quad (2x2) display is
selected, the ( Setup ) button allows
you to select the layout of the channels
to be displayed on-screen.
The drop lists are shown on-screen
accordingly to the grid layout mode
selected. You can easily choose each
individual camera channel to be
displayed in the selected grid segment
visually. If you have less cameras than
available grid segments, then those
112 of 151
Advertisement
Table of Contents
