Figure 3-7 Cycling Through The Video Channels In Quad View - Gatekeeper G4-504HD2a User's Operating Manual

G4-504HD2a User Guide
In 4 Camera On-screen View mode, the screen is split into four sections (using a 2x2 grid layout)
▪
and video from four cameras is simultaneously shown on the screen.
With the Finger Mouse or the ICD2, you could also click on any video stream on the (2x2) grid
▪
display to immediately jump to that channel and display the video from the corresponding
camera. This will switch the display to Single Camera On-screen View to display the video from
the selected camera.
You can cycle through the available channels iteratively in (2x2) grid display mode by pressing
▪
the zero key [0] on the ICD2.

Figure 3-7 Cycling through the Video Channels in Quad View

9 Camera On-screen View
In 9 Camera On-screen View mode, the screen is split into nine sections (using a 3x3 grid layout)
▪
and video from all available cameras is simultaneously shown on the screen.
In order to select a specific camera for viewing, you may press any of the keys [1-9] on the ICD2
▪
to immediately jump to that channel and display the video stream from the corresponding
camera. This will switch the display to Single Camera On-screen View to display the video from
the selected camera.
Alternatively, with the Finger Mouse or the ICD2, you could also click on any video stream on
▪
the (3x3) grid display to immediately jump to that channel and display the video from the
corresponding camera. This will switch the display to Single Camera On-screen View to display
the video from the selected camera.
You can cycle through the available channels iteratively in (3x3) grid display mode by pressing
▪
the zero key [0] on the ICD2.
Notes
Channels which do not have cameras configured on them will just show a black display.
▪
Any channel which is configured with a camera, but is not receiving any video signal
▪
from that camera will show a Video Loss message on the screen.
Getting Started 24 of 151