Table of Contents
Advertisement
Configuring 10-digit Dialing
The display flashes ENTER AREA CODE and
Enter the area code(s) for numbers that you dial
using 10 digits (e.g., 720-555-1234). You can store
up to three area codes for 10-digit dialing. Press
DIAL/ENTER
when you are done. If there is no number
you dial using 10 digits, then press
Configure outside line access
The display indicates the OUTSIDE ACCESS? prompt.
Enter the outside line access code (up to 4 digits),
#
or press
if your extension is configured for
direct line access. Press the
If you enter an outside line access code by mistake,
DELETE
press the
the digits.
Configure Paging
1
Press
to configure for External Paging or press
to configure for Group Paging to telephone sets. If you
select Group Paging, you must also enter a ring group
number (300–309).
ADJUSTING THE DISPLAY ANGLE
You can optimize the LCD display by adjusting the viewing angle. To adjust the
LCD viewing angle, move the rear edge of the LCD module up or down.
ADJUSTING THE DISPLAY CONTRAST
The display can be adjusted to suit the light level of your room and your viewing
preference. To make the contrast of the display lighter or darker, press the
button to the right of the screen until the desired contrast is reached.
W W W.T A L K S W I T C H . CO M
DIAL/ENTER
DIAL/ENTER
button or the
T S - 4 0 0 U S E R G U I D E
10 DIGITS
DIAL.
.
button.
button to delete
2
7 2 0
ENTER AREA CODE
10 DIGITS DIAL
_ _ _ _
OUTSIDE ACCESS?
9 _ _ _
OUTSIDE ACCESS?
_
>1=PA
2=GROUP
7
Advertisement
Table of Contents
