Emerson Machinery Health AMS 6300 SIS Operating Manual page 86

Configuration
February 2023
Enable test values
Select Enable test values to open the Enable test values dialog for activating or
deactivating of both configured test values
information on the use of test values.
Figure 5-14: Dialog Enable test values
Proof test
Select Proof test to open the Proof test dialog. Within the context of SIL compliant
installations, the execution of a proof test may be an important requirement. For further
information see safety manual "SFM 6100 9020 safety manual AMS 6300 SIS".
describes this test.
Reset start counter
Select Reset start counter to set the counters Reboots and Cold starts to zero.
Reset latch
Select Reset latch to reset all latched alarms and the Trip output, provided the measuring
value is in the good range again (below limit value including hysteresis).
Reset rotation
Select Reset rotation to reset the current information of the rotational direction according
to the configured Preferred rotational direction (see
command has an effect on the function outputs (digital outputs) configured for the
output of function Direction of rotation and for any further messages regarding the
rotational direction.
Reset speed peak
Select Reset speed peak to set the detected maximum speed, stored in this monitor, to
zero.
Set monitor keyword
Select Set monitor keyword to open the New monitor Keyword dialog (see
The keyword is stored in the monitor and checked when sending the configuration.
Operation of a monitor without keyword protection is not possible.
The keyword must consist of at least 6 and not more than 20 characters. The following
characters are permitted:
• a to z
• A to Z
• 0 to 9
86
(Figure 5-14). See Test values
Group Measuring
Operating Manual
MHM-97442
for further
Proof test
functions). The
Figure 5-15).
MHM-97442, Rev. 2.06