Table of Contents
Advertisement
Visualization
February 2023
Group Trigger threshold
The trigger thresholds currently adjusted are displayed here. These values may vary
depending on the distance between sensor and trigger wheel if function Basic Settings →
Offset tracking has been activated.
Group Analog outputs
The set value of both current outputs is shown here — Output 1 and Output 2. The
indicated set value depends on the settings on tab Analog Output 1 and Analog Output
2. The corresponding current value must appear at the respective current output.
Group Monitor information
In these fields statistical values, the current temperature, and the maximum temperature
measured with the internal temperature sensor are displayed.
Reboots (<24 h)
This counter increases when an internal fault is detected. If no further faults are detected
within the next 24 hours, the counter is reset to 0. If altogether 5 faults are detected, the
monitor is switched off.
Reboots
This counter increases after every monitor restart, initiated by the software.
With an existing online connection to the monitor, use command Monitor → Reset start
counter to reset the counter Reboots. A corresponding access authorization is required.
Cold starts
This counter is increased after every power-on.
With an existing online connection to the monitor, use command Monitor → Reset start
counter to reset the counter Cold starts. A corresponding access authorization is
required.
Temperature
The current temperature, measured by the monitor internal temperature sensor, is
displayed here.
Maximum temperature
The maximum temperature, measured by the internal temperature sensor, is displayed
here .
Group Versions
The firmware versions are shown here, detailed classified according to safe μC and sub μC.
128
Operating Manual
MHM-97442
MHM-97442, Rev. 2.06
Advertisement
Table of Contents
