Table of Contents
Advertisement
Configuration
February 2023
Figure 5-39: Diagram current output smoothing
Maximum speed
Depending on the setting of parameter Characteristic, define here the end value for the
asymmetric range for the scaling of the current output on Speed (see
the symmetric range for the scaling of the current output on Acceleration (see
5-41). If Acceleration was chosen for parameter Characteristic, this parameter defines the
start and end value of the symmetrical range around 0 rpm/s. If the acceleration is 0
rpm/s, the current output shows 10 mA respectively 12 mA. In this way it is possible to
output positive and negative acceleration values through the current output.
Figure 5-40: Diagram current output scaling - speed
110
or Maximum acceleration
Operating Manual
MHM-97442
Figure
5-40) or for
Figure
MHM-97442, Rev. 2.06
Advertisement
Table of Contents
