Table of Contents
Advertisement
Operating Manual
MHM-97442
Prioritized
Generally, the configuration software continuously scans all detected COM ports for
connected monitors. COM ports with a checkmark in the corresponding box are scanned
at a higher priority.
Error occurred
This field shows, whether an error has occurred at this port.
485 Start Address / 485 End Address
Enter here an address range. This range is scanned by the software for connected monitors
for the RS 485 bus communication. This has the advantage that not the entire address
range must be scanned. To detect all connected monitors, the device addresses of all
monitors should be known. The maximum address range is 0 to 255.
Click OK to accept the modifications and to close the window. Click Cancel to close the
window without accepting the changes.
Tools
Configuration differences
Click Configuration differences to open the window for comparison of two or three
configurations. Stored configuration files or configurations from connected monitors may
be used.
Figure 5-9
project are displayed in the upper section. A checkbox is assigned to each monitor. Place a
checkmark in the respective box to select two or three monitors at max for the
configuration comparison. Click Update Report to start the comparison of the selected
monitors.
Rows with differences within the configurations are colored red. The individual parameters
are grouped according to the configuration tabs. The tab names are colored blue.
Use the printing functionality if the result of the comparison shall be printed, for example,
for archiving purposes.
Click Close Report to close the window of the comparison function.
MHM-97442, Rev. 2.06
shows the window of the comparison functionality. All monitors of the current
Configuration
February 2023
77
Advertisement
Table of Contents
