Table of Contents
Advertisement
12.12 Synchronize Time
Synchronize the device time when it is inconsistent with the actual time.
Steps
1. Go to Configuration → System → System Settings → Time Settings.
2. Select Time Zone according to the device location.
3. Select the time synchronization mode.
– If an NTP server is available, select NTP and enter NTP server information to synchronize the
device time with that of the NTP server.
– Select Manual Time Sync. and set time to customize the device time.
– Select Manual Time Sync. and check Sync. with computer time to synchronize the device
time with that of the computer.
4. Click Save.
12.13 Configure DST
If the region where the device is located adopts Daylight Saving Time (DST), you can set this
function.
Steps
1. Go to Configuration → System → System Settings → DST.
2. Check Enable DST.
3. Set Start Time, End Time, and DST Bias.
4. Click Save.
12.14 Configure Local Output
When the operation menu cannot be displayed on the monitor due to that the main and auxiliary
interfaces have switched or the output resolution does not match with the actual display, you can
switch between the main and auxiliary interfaces via the web browser.
Go to Configuration → System → System Settings → Menu Output, and select Menu Output and
VGA Resolution.
Note
The function varies with device models. The actual device prevails.
12.15 Configure RS-232
Set RS-232 parameters if you need to debug the device via RS-232 serial port, or peripheral devices
Mobile Video Recorder User Manual
61
Advertisement
Table of Contents
