Configure Local Network - LINOVISION MNVR7608 User Manual

Note
If you want to enable DHCP, the network that the device is connected to should support
DHCP (Dynamic Host Configuration Protocol).
– Uncheck DHCP, and edit the IPv4 parameters.
4. Click Save.
5. Go to Configuration → Network → Advanced Settings → Wi-Fi to set Wi-Fi parameters.
1) Click Wi-Fi Configuration.
2) Check Enable Wi-Fi.
3) Click Search to search available Wi-Fi.
4) Select a Wi-Fi in Wireless List.
The related information will be matched automatically.
5) Select Network Mode as Managed.
6) Enter the Wi-Fi key.
6. Click Save.
7. Optional: Go to Configuration → Network → Advanced Settings → Wi-Fi and click Wi-Fi Status
to view Wi-Fi status.
Result
After the Wi-Fi is connected, you can get access to the device via the WLAN IP address in
Configuration → Network → Basic Settings → TCP/IP.

4.1.3 Configure Local Network

When the device is connected to the network via network cables, and the IP address needs to be
edited to get access to the network or connect the IP cameras, set the LAN parameters.
Steps
1. Go to Configuration → Network → Basic Settings → TCP/IP.
2. Click Lan.
Mobile Video Recorder User Manual
17