Table of Contents
Advertisement
3.1.3 Edit IP Camera
You can visit, edit, or delete the added IP cameras.
Before You Start
If the device contains only one NIC, you can visit the added IP camera directly. If the device
contains dual NICs, you need to enable virtual host function before visiting the added IP camera.
Go to Configuration → Network → Advanced Settings → Other, and check Enable Virtual Host.
Steps
1. Go to Configuration → System → Camera Management → IP Camera.
2. You can visit, edit, or delete the added IP cameras.
– Click the address of the added IP camera to get access to the camera according to the
prompt.
– When the IP addresses conflict, you can edit the IP camera information.
1. Check the IP camera to be edited.
2. Click Modify, and edit the camera information.
3. Click OK.
– Check IP camera(s) and click Delete to delete the added IP camera(s).
3.2 Record and Capture
To record the videos of the connected cameras, or capture the license plate pictures if you enable
license plate recognition, you need to install a storage media and format it, and configure the
recording schedule, or configure the FTP server to upload the pictures.
3.2.1 Format Storage Media
A newly installed storage media must be initialized before it can be used.
Before You Start
Install a storage media.
Steps
1. Go to Configuration → Storage → Storage Management → HDD Management.
2. Check the storage media and click Format.
Result
After format, the storage media status should be Normal.
3.2.2 Configure FTP
Configure FTP parameters if you want to upload the captured license plate pictures to the FTP
Mobile Video Recorder User Manual
7
Advertisement
Table of Contents
